Description

With the Dayton Audio DAEX32EP-4 Thruster exciter, you can turn large, rigid surfaces into speakers.

Product Highlights

• A quick and secure installation with pre-applied 3M™ VHB™ adhesive

• A proprietary two-layer voice coil and a rare-earth neodymium motor

• Heavy-duty and robust design with a 32 mm voice coil attached to a steel spider

• 4 ohms impedance for use with small, Class D amplifiers

• 40 watt RMS power handling for high output

Product Description

Dayton Audio’s DAEX32EP-4 Thruster exciter is built to turn thick, rigid, large surfaces into speakers. The 32 mm voice coil is attached to a steel spider for maximum restoring force when large amounts of power are applied. It’s perfect for large glass panes, furniture, and surfaces that would normally resist the effects of an exciter.
A neodymium magnet is employed to create maximum magnetic flux around the proprietary voice coil. This increases sensitivity when compared to similar sized exciters. This then reduces the power requirements and makes it possible to use very small Class D audio amplifiers, without having to sacrifice total output.

3M VHB (Very High Bond) adhesive is pre-applied to the main body to ensure maximum acoustic energy transfer between the transducer and the surface. Two male spade quick-disconnect terminals are built onto the main body for easy electrical connection.

Note: An exciter’s frequency response and sensitivity are completely dependent on the exciter’s designated surface. Thinner, smaller materials will tend to be louder and create a mid/tweeter response. Thicker, larger materials (with multiple exciters) will be slightly quieter but result in a more full-range sound.

Adhesive dimensions: 41.75 mm (outside diameter), 21.75 (inside diameter)