The Dayton Audio DAEX32Q-4 dual spring balanced exciter has more linear movement to deliver extremely accurate response while producing lower distortion, when applied to vertical surfaces.

Product Highlights

• Quick, secure installation with pre-applied 3M™ VHB™ adhesive

• 32 mm two layer voice coil for high, 20 watts RMS, power handling

• Makes the most out of small class D amplifiers, with 4 ohms impedance

• Dual steel spider design to better support the large neodymium motor

Product Description

The Dayton Audio DAEX32Q-4an turns most flat, rigid surfaces into a speaker. Designed specifically for mounting to vertical surfaces, this exciter uses a dual spring spider to better support the large neodymium motor providing improved linearity. This exciter can handle up to 40 watts peak, with its 2-layer 32 mm voice coil, for high output even when attached to thicker surfaces. 3M VHB (Very High Bond) adhesive is pre-applied to ensure maximum acoustic energy transfer between the transducer and the surface, just peel and stick. This exciter is perfect for turning whatever you can imagine into a speaker such as monitors, cabinet doors, garage doors, windows, etc.

Note: An exciter’s frequency response and sensitivity are completely dependent on the exciter’s designated surface. Smaller, thinner materials will tend to be louder and create a mid/tweeter response. Larger, thicker materials (with multiple exciters) will be slightly quieter but result in a more full-range sound.

Specifications: • Power handling: 20 watts RMS, 40 watts peak • VCdia: 32 mm • Nominal impedance: 4 ohms • Re: 3.2 ohms • Le: 0.22 mH • Fs (uncoupled): 298 Hz • Dimensions: 2.38″ (60.5 mm) dia. x 0.78″ (19.9 mm) H • Adhesive dimensions: 1.26″ (32 mm) outside diameter, 0.9″ (23 mm) inside diameter • Weight: 132.6 grams.